Home : Product Lines : Electro Hydraulic : Solenoid Actuators
Spool-Lock™ Solenoid
Configure this product and compare it with others using our Product Catalog
- Submersible design to seal against water ingression, with a protection rating up to IP-X7
- Rated Voltage: 12 or 24 VDC ± 10%
- Rated Current: 0.77 Amps (12 VDC)
;0.39 Amps (24 VDC) - Temperature Range: -30°C to +90°C
- Force of locking/holding pin in extended position: De-energized position: 0.41 lbs. [1.82 N]
- Working Stroke: 3.6 mm (0.14 in.)
- Locking/holding pin diameter: 6.35 mm (0.25 in.)
- Duty cycle: 100% continuous
- Recommended torque: 40 ft-lbs (54.23 N-M) Maximum torque 45 ft-lbs (61.1 N-M)
- RoHS Compliant
- Durable construction insures operation in severe temperature conditions
- Can be mounted directly without the need for additional hardware
- 9/16-18 UNF-2A mounting thread standard with other threads available on request
Click here to ask MSA for additional information about Totally Custom Spool Lock Solenoids.
In customer applications where the performance, mounting, or other uniquely demanding technical requirements cannot be met by modifying our standard spool lock solenoid, Magnet-Schultz of America can provide a totally custom spool lock design.
Typical design features which can be tailored to meet the customer's requirements are:
- Stroke
- Internal pressure ratings
- Mating threads
- Manual actuation
- Different connectors/terminations, and lead wire lengths
Increased user safety and system reliability are important benefits of Spool Lock solenoids by Magnet-Schultz of America. This variant on the well known shot bolt solenoid is intended for hydraulic applications, and is pre-threaded for screwing into a standard hydraulic manifold. When activated, the spool lock solenoid’s actuator locks firmly in place, and will not change its state unless authorized by a subsequent electrical input. Commonly found on boom lifts and other types of aerial work platforms, the presence of spool lock solenoids create assurance that a sudden change in solenoid state will not cause a dangerous change in a worker’s position.